5 MHz Distribution Amplifier - FS730

Sine wave outputs (+13 dbm) Low additive phase noise High channel-to-channel isolation FS735 Distribution Amplifiers The FS730/FS735 Series Distribution Amplifiers are used to distribute a low noise 5 MHz frequency reference. Each amplifier has one input and seven outputs, all on BNC connectors. The input is coupled through a series LC network allowing the use of inputs with a DC offset. The input source impedance is 50 Ω at 5 MHz. FS735 Distribution Amplifier FS730 5 MHz Distribution Amplifier FS735 3D Step File FS730 3D Step File FS735 Volatility Statement FS740 GPS Frequency Std. PRS10 Rb Oscillator FS752 GPS System FS725 Rb Freq. Std. FS740 GPS Freq. Std. PRS10 Rb clock FS735 Distr. Amp. SG380 RF Sig. Gen. FS730 & FS735 5 MHz Distribution Amplifiers FS730 & FS735 5 MHz Distribution Amps The input is conditioned by a limiter which provides several advantages. It removes amplitude modulation from the input signal, outputs have fixed amplitude, and input noise that occurs more than 50 mV away from the zero-crossing is blocked. Virtually any waveform with a duty cycle near 50 % may be used as an input. The input limiter is followed by a bandpass filter and a fixed gain amplifier. This signal is passed to seven output amplifiers, each of which is followed by a low pass filter and an output transformer. All of the outputs have 50 Ω source impedance and provide a 1 Vrms (+13 dBm) sine wave into a 50 Ω load. There are four indicator LEDs. The “power” LED indicates that the unit has AC power. The “signal” LED indicates that an input signal is present. The “overload” LED indicates that the input signal has excessive amplitude. The “fault” LED indicates one or more of these conditions: no input signal, excessive input signal, no output signal, or low internal DC power supply. The FS73x series of products can be configured as half-width, 1U, benchtop instruments (FS730) shown above, or in full-width, 1U, 19" rack-mount enclosures (FS735) shown below. The FS730/2 model provides 7 output BNC connectors on the front panel, and can be rack mounted with an optional rack mount kit. The FS735/2/2 model provides 14 output BNC connectors on the rear panel, with status indicators on the front panel. Several types of distribution amplifiers are available as listed below. Different types may be combined within the FS735 chassis. Option 1 — 10 MHz distribution amplifier Option 2 — 5 MHz distribution amplifier Option 3 — CMOS logic distribution amplifier Option 4 — Broadband 50 Ω distribution amplifier Option 5 — Broadband 75 Ω distribution amplifier FS730/735 Specifications 0 dBm to +16 dBm (0.6 V pp to 4 V pp ) Any with ≈ 50 % duty Series LC (Open at DC) +13 ±1 dBm (1 V rms , 2.82 V pp ) Transformer (short at DC) <-120 dBc within 100 kHz Phase noise (+7 dBm input) 10 W, 100/120/220/240 VAC, 50/60 Hz Dimensions FS730 FS735 8.3" × 1.5" × 8.0" (WHL) 17" × 1.5" × 8.0" (WHL) One year parts and labor on defects in materials and workmanship