CMOS Distribution Amplifier - FS730

High input impedance with hysteresis High current outputs Fast transition times Small insertion delay Low channel-to-channel timing skew FS735 Distribution Amplifiers The FS730/3 Series Distribution Amplifiers are used to distribute CMOS level logic pulses. Each amplifier has one input and seven outputs, all on BNC connectors. All inputs and outputs are logic levels. FS735 Distribution Amplifier FS730 Distribution Amplifier FS735 3D Step File FS730 3D Step File FS735 Volatility Statement FS740 GPS Frequency Std. PRS10 Rb Oscillator FS752 GPS System FS725 Rb Freq. Std. FS740 GPS Freq. Std. PRS10 Rb clock FS735 Distr. Amp. SG380 RF Sig. Gen. FS730 & FS735 CMOS Distribution Amplifiers FS730 & FS735 CMOS Distribution Amps The Schmitt trigger input has a switching threshold of +1.3 VDC with 0.35 V of hysteresis. The input impedance is 1 kΩ. Small Reflection Artifacts X Small Reflection Artifacts FS730 & FS735 Small Reflection Artifacts Each output has a 50 Ω source impedance with logic levels of 0 VDC and 5.0 VDC. The 50 Ω source impedance will reverse terminate reflected pulses when driving unterminated lines. High impedance loads will be driven to 5 V and 50 Ω loads will be driven to 2.5 VDC. All of the outputs are driven by separate drivers to provide high isolation. The outputs have fast transition times and very low overshoot. The polarity of each output may be configured with a jumper inside the unit: installing the polarity jumper inverts the corresponding output. As shipped, the outputs are non-inverting . The unit has two indicator LEDs. The “power” LED indicates that the unit has AC power. The “signal” LED will flash for 100 ms on each rising or falling edge seen at the input. The FS73x series of products can be configured as half-width, 1U, benchtop instruments (FS730) shown above, or in full-width, 1U, 19" rack-mount enclosures (FS735) shown below. The FS730/3 model provides 7 output BNC connectors on the front panel, and can be rack mounted with an optional rack The FS735/3/3 model provides 14 output BNC connectors on the rear panel, with status indicators on the front panel. Several types of distribution amplifiers are available as listed below. Different types may be combined within the FS735 chassis. Option 1 — 10 MHz distribution amplifier Option 2 — 5 MHz distribution amplifier Option 3 — CMOS logic distribution amplifier Option 4 — Broadband 50 Ω distribution amplifier Option 5 — Broadband 75 Ω distribution amplifier FS730 & FS735 Specifications Levels (high-Z load) 10 W, 100/120/220/240 VAC, 50/60 Hz Dimensions FS730 FS735 8.3" × 1.5" × 8.0" (WHL) 17" × 1.5" × 8.0" (WHL) One year parts and labor on defects in materials and workmanship